User Tools

Site Tools


doc:hw_commands

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
doc:hw_commands [2017/03/18 12:50] – [Protocol Specific Commands (P 6) for the CAN UDS Protocol] admindoc:hw_commands [2017/04/02 07:09] (current) – [Protocol Specific Commands (P 6) for the CAN UDS Protocol] admin
Line 91: Line 91:
 |  9  |  $xxx  |  0  | set ECU Response-ID (SENDID) (Default 0, makes SENDID= RECVID %%|%% 0x08)  |   | |  9  |  $xxx  |  0  | set ECU Response-ID (SENDID) (Default 0, makes SENDID= RECVID %%|%% 0x08)  |   |
 |  10  |  $xxx  |  0  | set Tester Present mask 02 xx (Default 0x80)  |   | |  10  |  $xxx  |  0  | set Tester Present mask 02 xx (Default 0x80)  |   |
-|  11  |  0 or 1  |  0  | set/resets the Ping Mode Flag  |   |+|  11  |  0 or 1  |  0  | set/resets the [[rfc_canuds-mode#ping_mode_scan_available_modules|Ping Mode]] Flag  |   |
  
 ==== Protocol Specific Commands (P 6) for the CAN Raw Protocol ==== ==== Protocol Specific Commands (P 6) for the CAN Raw Protocol ====
doc/hw_commands.txt · Last modified: 2017/04/02 07:09 by admin