doc:rfc_canraw-mode
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Last revisionBoth sides next revision | ||
doc:rfc_canraw-mode [2014/09/01 07:14] – [Examples] admin | doc:rfc_canraw-mode [2016/01/21 18:14] – admin | ||
---|---|---|---|
Line 80: | Line 80: | ||
- | The OOBD CAN raw format does not only allow single CAN frames, it can also send (if necessary) | + | The OOBD CAN raw format does not only allow single CAN frames, it can also send (if necessary) |
The data consists of one or more blocks: | The data consists of one or more blocks: | ||
Line 98: | Line 98: | ||
Following the scheme above, there can be so much blocks send in one go as fit into the input buffer of 4095 bytes. | Following the scheme above, there can be so much blocks send in one go as fit into the input buffer of 4095 bytes. | ||
+ | |||
+ | |||
+ | The whole sequence is only sent once. For repetition, the application need to raise the command again. | ||
doc/rfc_canraw-mode.txt · Last modified: 2016/10/30 09:22 by admin