doc:hw_commands
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
| doc:hw_commands [2016/11/19 11:50] – [Bus Specific Commands (P 8) for the CAN Bus, used in D2 Design] admin | doc:hw_commands [2016/11/27 17:05] – [Bus Generic Commands (P 9) for the CAN Bus] admin | ||
|---|---|---|---|
| Line 158: | Line 158: | ||
| | 0 | 0 | 0 |show info which interface/ | | 0 | 0 | 0 |show info which interface/ | ||
| | 0 | 3 | 0 |show info of CAN transceiver operating mode | | | | 0 | 3 | 0 |show info of CAN transceiver operating mode | | | ||
| - | | 0 | 4 | 0 |?? | | | + | | 0 | 4 | 0 |show info about CAN ID side and bitrate |
| - | | 0 | 5 | 1 |read different CAN error counters | | | + | | 0 | 5 | 1 |read different CAN counters: rx rxerr tx txerr rxerr2 txerr2 busoff buswarn buspass |
| | 0 | 5 | 2 |delete all software internal CAN error counters | | | | 0 | 5 | 2 |delete all software internal CAN error counters | | | ||
| | 0 | 10 | 0 |show all 11bit CAN-ID filter, each line with two 11bit CAN-filters like: | | 0 | 10 | 0 |show all 11bit CAN-ID filter, each line with two 11bit CAN-filters like: | ||
doc/hw_commands.txt · Last modified: 2017/04/02 07:09 by admin