A “portable” Flash & Test environment for the Dongle hardware can be installed on an empty USB-Stick (all older data on that stick will be ereased!). Just follow the instructions below:
Download and install Knoppix either on CD or, if you want to make your setting and installations permanent, use UNetBootIn install to it on a usb stick..
After installation on the stick, boot from the stick.
at the boot prompt type fb1024x768 as boot parameter to avoid crash during boot)
in /etc/network/interfaces add
auto eth0 iface eth0 inet dhcp
to get eth0 to work. Start it with ifup eth0
Open a bash terminal window
In case you are working from inside a corperate network, do not forget to set the system proxy environment variables before starting the setup process by typing the following commands into the terminal window:
export HTTP_HOST=your_proxy_hostname export HTTP_PORT=your_proxy_port_number
In case you have set up your Knoppix to run from usb stick and using persistent storage, you can place your above settings in the same format into a file named .oobd.conf in your home directory
copy the following text into the terminal and let it run:
test -f ~/.oobd.conf && source ~/.oobd.conf if [ "$HTTP_HOST" -a "$HTTP_PORT" ]; then export http_proxy="http://"$HTTP_HOST:$HTTP_PORT fi wget https://github.com/stko/oobd/trunk/tools/dongleTest/setup.sh -O setup.sh chmod +x setup.sh ./setup.sh
The setup will download a lot of software packages to extend your Knoppix system.
After finishing, you will find a OOBD Icon on your desktop which provides you with a menu to flash the bootloader and/or firmware via USB-Serial-Adaptor. You might also flash the firmware via bluetooth with an intact bootloader. It also contains a test via Bluetooth for a dongle which tests the hardware (LEDs, Buzzer, CAN & KL-Bus). For a successful CAN & KL-Test some special external hardware needs to be connected.