doc:hw_commands
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
doc:hw_commands [2016/05/20 14:22] – [Bus Generic Commands (P 9) for the CAN Bus] nexulm | doc:hw_commands [2016/11/19 11:50] – [Bus Specific Commands (P 8) for the CAN Bus, used in D2 Design] admin | ||
---|---|---|---|
Line 139: | Line 139: | ||
| 4 | 0 | 0 |HS-CAN (Relais switch - OFF) | | | | 4 | 0 | 0 |HS-CAN (Relais switch - OFF) | | | ||
| 4 | 1 | 0 |MS-CAN (Relais switch - ON) | | | | 4 | 1 | 0 |MS-CAN (Relais switch - ON) | | | ||
- | | 10 | | + | | 10 | < |
- | | 11 | | + | | 11 | < |
- | | 12 | | + | | 12 | < |
- | | 13 | | + | | 13 | < |
| 14 | 0 | 0 |set all 11bit CAN filter to CAN-ID $0000 and Mask-ID $07FF (= disable any CAN traffic to application) | | | | 14 | 0 | 0 |set all 11bit CAN filter to CAN-ID $0000 and Mask-ID $07FF (= disable any CAN traffic to application) | | | ||
+ | * N: number of filters is implementation depending, see ''# | ||
+ | |||
+ | The socketCAN implementation has some advanced filter settings. Please read the [[https:// | ||
\\ | \\ |
doc/hw_commands.txt · Last modified: 2017/04/02 07:09 by admin