Differences

This shows you the differences between two versions of the page.

--- doc:hw_commands [2014/07/08 12:37] – [Bus Specific Commands (P 8) for the CAN Bus, used in D2 Design] admin
+++ doc:hw_commands [2016/05/01 20:32] – [Protocol Specific Commands (P 6) for the CAN Raw Protocol] admin
@@ Line 94: / Line 94: @@
 ==== Protocol Specific Commands (P 6) for the CAN Raw Protocol ====
-No dedicated p- commands for this mode, as the function is mainly driven by the sent data content. For more details about the CAN Raw Mode, please refer to the [[rfc_canraw-mode|RFC CAN Raw Mode]]
+For more details about the CAN Raw Mode, please refer to the [[:doc:rfc_canraw-mode|RFC CAN Raw Mode]]
+^  Command  ^  Value1  ^  Value2  ^  Meaning  ^  Errorcodes  |
+|  1  |  |  |(PARAM_CANRAW_FRAME_DELAY, not used yet?) |  |
+|  2  |  |  |(PARAM_CANRAW_SENDID, not used yet?) |  |
+|  3  |  0..max  |  |repeats the sequence n+1 times. $FFFF means endless loop, send "p 6 3 0" to stop again. Note: This Counter needs to set again before each use, it's not "re-usable" |  |
+\\
 ==== Protocol Specific Commands (P 6) for the CAN RTD Protocol ====